“Dean number”的意思、由来-开放百科全书

The Dean number (De) is a dimensionless group in fluid mechanics, which occurs in the study of flow in curved pipes and channels. It is named after the British scientist W. R. Dean, who was the first to provide a theoretical solution of the fluid

motion through curved pipes for laminar flow by using a perturbation procedure from a Poiseuille flow in a straight pipe to a flow in a pipe with very small curvature.^[1]^[2]

Physical Context

If a fluid is moving along a straight pipe that after some point becomes curved, the centripetal forces at the bend will cause the fluid particles to change their main direction of motion. There will be an adverse pressure gradient generated from the curvature with an increase in pressure, therefore a decrease in velocity close to the convex wall, and the contrary will occur towards the outer side of the pipe. This gives rise to a secondary motion superposed on the primary flow, with the fluid in the centre of the pipe being swept towards the outer side of the bend and the fluid near the pipe wall will return towards the inside of the bend. This secondary motion is expected to appear as a pair of counter-rotating cells, which are called Dean vortices.

Definition

The Dean number is typically denoted by De (or Dn). For a flow in a pipe or tube it is defined as:

The Dean number is therefore the product of the Reynolds number (based on axial flow

through a pipe of diameter

) and the square root of the curvature ratio.

Turbulence transition

The flow is completely unidirectional for low Dean numbers (De < 40~60). As the Dean number increases between 40~60 to 64~75, some wavy perturbations can be observed in the cross-section, which evidences some secondary flow. At higher Dean numbers than that (De > 64~75) the pair of Dean vortices becomes stable, indicating a primary dynamic instability. A secondary instability appears for De > 75~200, where the vortices present undulations, twisting, and eventually merging and pair splitting. Fully turbulent flow forms for De > 400.^[3] Transition from laminar to turbulent flow has been also examined in a number of studies, even though no universal solution exists since the parameter is highly dependent on the curvature ratio.^[4] Somewhat unexpectedly, laminar flow can be maintained for larger Reynolds numbers (even by a factor of two for the highest curvature ratios studied) than for straight pipes, even though curvature is known to cause instability.^[5]

The Dean equations

The Dean number appears in the so-called Dean equations.^[6] These are an approximation to the full Navier–Stokes equations for the steady axially uniform flow of a Newtonian fluid in a toroidal pipe, obtained by retaining just the leading order curvature effects (i.e. the leading-order equations for

We use orthogonal coordinates

with corresponding unit vectors

aligned with the centre-line of the pipe at each point. The axial direction is

, with

being the normal in the plane of the centre-line, and

the binormal. For an axial flow driven by a pressure gradient

, the axial velocity

is scaled with

. The cross-stream velocities

are scaled with

, and cross-stream pressures with

. Lengths are scaled with the tube radius

In terms of these non-dimensional variables and coordinates, the Dean equations are then

The Dean number D is the only parameter left in the system, and encapsulates the leading order curvature effects. Higher-order approximations will involve additional parameters.

For weak curvature effects (small D), the Dean equations can be solved as a series expansion in D. The first correction to the leading-order axial Poiseuille flow is a pair of vortices in the cross-section carrying flow form the inside to the outside of the bend across the centre and back around the edges. This solution is stable up to a critical Dean number

.^[7] For larger D, there are multiple solutions, many of which are unstable.

References

1. ^{{cite journal | last1 = Dean | first1 = W. R. | year = 1927 | title = Note on the motion of fluid in a curved pipe | url = http://www.informaworld.com/openurl?genre=article&issn=1941-5982&volume=4&issue=20&spage=208 | journal = Phil. Mag. | volume = 20 | issue = 20| pages = 208–223 | doi = 10.1080/14786440708564324}}
2. ^{{cite journal | last1 = Dean | first1 = W. R. | year = 1928 | title = The streamline motion of fluid in a curved pipe | url = http://www.informaworld.com/openurl?genre=article&issn=1941-5982&volume=5&issue=30&spage=673 | journal = Phil. Mag. | series=Series 7 | volume = 5 | issue = 30| pages = 673–695| doi = 10.1080/14786440408564513 }}
3. ^Ligrani, Phillip M. [https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19950005258.pdf "A Study of Dean Vortex Development and Structure in a Curved Rectangular Channel With Aspect Ratio of 40 at Dean Numbers up to 430"], U.S. Army Research Laboratory (Contractor Report ARL-CR-l44) and Lewis Research Center (NASA Contractor Report 4607), July 1994. Retrieved on 11 July 2017.
4. ^{{cite thesis | last1 = Kalpakli | first1 = Athanasia| year = 2012 | title = Experimental study of turbulent flows through pipe bends | url = http://kth.diva-portal.org/smash/get/diva2:515647/FULLTEXT02| pages = 461–512 | publisher = Royal Institute of Technology KTH Mechanics| place = Stockholm, Sweden }}
5. ^{{cite journal | last1 = Taylor | first1 = G. I.| year = 1929| title = The criterion for turbulence in curved pipes| url = http://rspa.royalsocietypublishing.org/content/124/794/243| journal = Proceedings of the Royal Society of London A: Mathematical, Physical and Engineering Sciences| volume = 124 | issue = 794| pages = 243–249| doi = 10.1098/rspa.1929.0111 | bibcode = 1929RSPSA.124..243T}}
6. ^Mestel, J. Flow in curved pipes: The Dean equations, Lecture Handout for Course M4A33, Imperial College.
7. ^{{cite journal | last1 = Dennis | first1 = C. R. | last2 = Ng | first2 = M. | year = 1982 | title = Dual solutions for steady laminar-flow through a curved tube | url = | journal = Q. J. Mech. Appl. Math. | volume = 35 | issue = 3| page = 305 | doi=10.1093/qjmam/35.3.305}}