1. Mucoadhesive/mucosa interaction

2. Bonding mechanisms

3. Stages of mucoadhesive process
     Contact stage    Adsorption theory    Wettability theory    Consolidation stage    Strong and prolonged adhesion    Macromolecular interpenetration theory    Dehydration theory  

4. Mucoadhesives in drug delivery
    Dosage Forms  Tablets  Patches  Gels  Solutions 

5. Routes of Administration
     Oromucosal   Nasal    Ocular    Intravesical  

6. See also

7. References

Mucoadhesive/mucosa interaction

Mucoadhesion involves several types of bonding mechanisms, and it is the interaction between each process that allows for the adhesive process. The major categories are wetting theory, adsorption theory, diffusion theory, electronic theory, and fracture theory.^[3] Specific processes include mechanical interlocking, electrostatic, diffusion interpenetration, adsorption and fracture processes.^[4]

Bonding mechanisms

Stages of mucoadhesive process

The mucoadhesive process will differ greatly depending on the surface and properties of the adhesive. However, two general steps of the process have been identified: the contact stage and the consolidation stage.^[1]

Contact stage

The contact stage is the initial wetting that occurs between the adhesive and membrane. This can occur mechanically by bringing together the two surfaces, or through the bodily systems, like when particles are deposited in the nasal cavity by inhalation. The principles of initial adsorption of small molecule adsobates can be described by DLVO theory.^[1]

Adsorption theory

According to DLVO theory, particles are held in suspension by a balance of attractive and repulsive forces. This theory can be applied to the adsorption of small molecules like mucoadhesive polymers, on surfaces, like mucus layers. Particles in general experience attractive van der Waals forces that promote coagulation; in the context of adsorption, the particle and mucus layers are naturally attracted. The attractive forces between particles increases with decreasing particle size due to increasing surface-area-to-volume ratio. This increases the strength of van der Waals interactions, so smaller particles should be easier to adsorb onto mucus membranes.^[1]

Wettability theory

The initial adsorption of the molecule adhesive will also depend on the wetting between the adhesive and membrane. This can be described using Young's equation:

where is the interfacial tension between the membrane and gas or bodily environment, is the interfacial tension between the bioadhesive and membrane, is the interfacial tension between the bioadhesive and bodily environment, and is the contact angle of the bioadhesive on the membrane. The ideal contact angle is 0° meaning the bioadhesive perfectly wets the membrane and good contact is achieved. The interfacial tensions can be measured using common experimental techniques such as a Wilhelmy plate or the Du Noüy ring method to predict if the adhesive will make good contact with the membrane.^[8]

Consolidation stage

Strong and prolonged adhesion

The consolidation stage of mucoadhesion involves the establishment of adhesive interactions to reinforce strong or prolonged adhesion. When moisture is present, mucoadhesive materials become activated and the system becomes plasticized.^[7] This stimulus allows the mucoadhesive molecules to separate and break free while proceeding to link up by weak van der Waals and hydrogen bonds.^[7] Consolidation factors are essential for the surface when exposed to significant dislodging stresses.^[1] Multiple mucoadhesion theories exist that explain the consolidation stage, the main two which focus on macromolecular interpenetration and dehydration.

Macromolecular interpenetration theory

The Macromolecular Interpenetration theory, also known as the diffusion theory, states that the mucoadhesive molecules and mucus glycoproteins mutually interact by means of interpenetration of their chains and the forming of secondary semi-permanent adhesive bonds.^[7] It is necessary that the mucoadhesive device has features or properties that favor both chemical and mechanical interactions for the macromolecular interpenetration theory to take place.^[7] Molecules that can present mucoadhesive properties are molecules with hydrogen bond building groups, high molecular weight, flexible chains, and surface active properties.^[7]

It is perceived that increase in adhesion force is associated with the degree of penetration of polymer chains.^[7] Literature states that the degree of penetration required for efficient bioadhesive bonds lies in the range of 0.2-0.5μm.^[7] The following equation can be used to estimate the degree of penetration of polymer and mucus chains:

with as contact time and as the diffusion coefficient of the mucoadhesive material in the mucus.^[7] Maximum adhesion strength is reached when penetration depth is approximately equal to polymer chain size.^[7] Properties of mutual solubility and structural similarity will improve the mucoadhesive bond.^[1]

Dehydration theory

The dehydration theory explains why mucoadhesion can arise rapidly. When two gels capable of rapid gelation in an aqueous environment are brought into contact, movement occurs between the two gels until a state of equilibrium is reached.^[1] Gels associated with a strong affinity for water will have high osmotic pressures and large swelling forces.^[1] The difference in osmotic pressure when these gels contact mucus gels will draw water into the formulation and quickly dehydrate the mucus gel, forcing intermixing and consolidation until equilibrium results.^[9]

This mixture of formulation and mucus can increase contact time with the mucus membrane, leading to the consolidation of the adhesive bond.^[9] However, the dehydration theory does not apply to solid formulations or highly hydrated forms.^[1]

Mucoadhesives in drug delivery

Depending on the dosage form and route, mucoadhesives may be used for either local or systemic administration of pharmaceuticals. An overview on the mucoadhesive properties of mucoadhesives is provided by Vjera Grabovac and Andreas Bernkop-Schnürch.^[10] The bioavailability of such drugs is affected by many factors unique to each route of application. In general, mucoadhesives work to increase the contact time at these sites, prolonging the residence time and maintaining an effective release rate. These polymeric coatings may be applied to a wide variety of liquid and solid dosages, each specially suited for the route of administration.

Dosage Forms

Tablets

Patches

In general, patches consist of three separate layers that contribute and control the release of medicine. The outer impermeable backing layer controls the direction of release and reduces drug loss away from the site of contact. It also protects the other layers and acts as a mechanical support. The middle reservoir layer holds the drug and is tailored to provide the specified dosage. The final inner layer consists of the mucoadhesive, allowing the patch to adhere to the specified mucosa.^[7]

Gels

As a liquid or semisolid dosage, gels are typically used where a solid form would affect the patient’s comfort. As a trade-off, conventional gels have poor retention rates. This results in unpredictable losses of the drug, as the non-solid dosage is unable to maintain its position at the site of administration. Mucoadhesives increase retention by dynamically increasing the viscosity of the gel after application. This allows the gel to effectively administer the drug at the local site while maintaining the comfort of the patient.^[7]

Solutions

These dosage forms are commonly used to deliver drugs to the eye and nasal cavity. They often include mucoadhesive polymers to improve retention on dynamic mucosal surfaces. Some advanced eye drop formulations may also turn from a liquid to a gel (so called in situ gelling systems) upon drug administration. For example, gel-forming solutions containing Pluronics could be used to improve the efficiency of eye drops and provide better retention on ocular surfaces.^[11]

Routes of Administration

Oromucosal

With a 0.1-0.7 mm thick mucus layer, the oral cavity serves as an important route of administration for mucoadhesive dosages. Permeation sites can be separated into two groups: sublingual and buccal, in which the former is much more permeable than the latter. However, the sublingual mucosa also produces more saliva, resulting in relatively low retention rates. Thus, sublingual mucosa is preferable for rapid onset and short duration treatments, while the buccal mucosa is more appropriate for longer dosage and onset times. Because of this dichotomy, the oral cavity is suitable for both local and systemic administration. Some common dosage forms for the oral cavity include gels, ointments, patches, and tablets. Depending on the dosage form, some drug loss can occur due to swallowing of saliva. This can be minimized by layering the side of the dosage facing the oral cavity with an impermeable coating(,) commonly seen in patches.^[12]

Nasal

With an active surface area of 160 cm², the nasal cavity is another noteworthy route of mucoadhesive administration. Due to the sweeping motion of the cilia that lines the mucosa, nasal mucus has a quick turnover of 10 to 15 minutes. Because of this, the nasal cavity is most suitable for rapid, local medicinal dosages. Additionally, its close proximity to the blood-brain barrier makes it a convenient route for administering specialized drugs to the central nervous system. Gels, solutions, and aerosols are common dosage forms in the nasal cavity. However, recent research into particles and microspheres have shown increased bioavailability over non-solid forms of medicine largely due to the use of mucoadhesives.^[13]

Ocular

Within the eye, it is difficult to achieve therapeutic concentrations through systemic administration. Often, other parts of the body will reach toxic levels of the medication before the eye reaches the treatment concentration. Consequently, direct administration through the fibrous tunic is common. This is made difficult due to the numerous defense mechanisms in place, such as blinking, tear production, and the tightness of the corneal epithelium. Estimates put tear turnover rates at 5 minutes, meaning most conventional drugs are not retained for long periods of time. Mucoadhesives increase retention rates, either by enhancing the viscosity or bonding directly to one of the mucosae surrounding the eye.^[12][14]

Intravesical

Intravesical drug administration is the delivery of pharmaceuticals to the urinary bladder through a catheter.^[15] This route of administration is used for the therapy of bladder cancer and interstitial cystitis. The retention of dosage forms in the bladder is relatively poor, which is related to the need for a periodical urine voiding. Some mucoadhesive materials are able to stick to mucosal lining in the bladder, resist urine wash out effects and provide a sustained drug delivery.^[16][17]

See also

• Bioadhesives
• Thiomer
• Wetting
• Adsorption
• DLVO theory

References

• Phone booth
• Phone Booth
• Phone Booth (film)
• Phone Booth (movie)
• Phone box
• Phone call
• Phone card
• Phone-card collecting
• Phonecia
• Phonecian
• Phone company
• Phone connector
• Phone connector (audio)
• Phone (film)
• Phone fraud
• PhoneGaim
• Phone-in
• Phone interview
• Phone jammer
• Phone line
• Phone losers of america
• Phone Losers of America
• Phonem
• Phoneme
• Phonemes