| 词条 | R800 (CPU) |
| 释义 |
The R800 is the central processing unit used in the MSX Turbo-R home computer. The R800 was designed by ASCII Corporation of Japan and built by Mitsui & Co., Ltd.. The goals were to have the fastest CPU possible, while maintaining compatibility with old MSX Zilog Z80-based hardware and software. CompatibilityIn order to preserve software compatibility with old MSX software, the R800 uses a superset of the Z80 instruction set. In addition to all the Z80 opcodes, two multiplication instructions were added, MULUB (8-bit), and MULUW (16-bit). Also, many of the undocumented Z80 instructions were made official, including all the opcodes dealing with IX and IY as 8-bit registers (IXH, IXL, IYH, IYL). As the R800 is not based directly on the Z80, but stems from the Z800 family, it lacks some of the other undocumented Z80 features. For instance, the undocumented flags represented in bits 3 and 5 of the F register don't assume the same values as in Z80 (causing it to fail ZEXALL tests) and the undocumented opcode often called SLL is just an alias of the SLA instruction. Hardware changesOn the hardware side, radical changes were made. The internal 4-bit ALU[1] of the Z80 was replaced with a new 16-bit ALU. Opcodes like ADD HL, BC, that previously took 11 clock cycles, now can run as fast as only one bus cycle (in some conditions). The maximum CPU clock speed was also increased to 14.32 MHz—four times as fast as the original 3.57 MHz Z80 used in the MSX, and the bus clock was increased to 7.16 MHz. The data bus remained 8-bit to maintain compatibility with old hardware. Fetching opcodesAdditional changes were made in the way the CPU fetches opcodes. The original Z80 uses 4 cycles to fetch a simple instruction like OR A, and an additional waitstate is issued on the MSX architecture. A review of the Z80 fetch mechanism in a typical MSX environment is needed to understand the R800:
Since most implementations of MSX use RAM memory disposed in a 256×256 bytes block, two cycles are required to set the address for the fetch. The R800 avoids this by remembering the last known state of the higher 8-bits. If the next instruction is in the same 256-byte boundaries, the higher 8-bits are not set, and a cycle is saved. However, on the Z80, the refresh cycles destroy the information on the higher bits, so a workaround was needed. The solution used in the R800 was to refresh entire blocks of RAM, instead of refreshing one line of RAM on each instruction issued. Each 30μs, the CPU is halted for 4μs, this time is used to refresh a block of the RAM. Since there's no refresh in between fetch instructions, and the waitstate is removed due to faster RAM chips, simple instructions can be issued using only one cycle. This cycle would be cycle 2 in the Z80 example above; cycle 1 becomes optional, and it's only issued when the program crosses a 256-byte boundary. External hardwareAll this only applies to the fast RAM used on the MSX turboR. External hardware, connected through cartridge slots, uses timings similar to Z80. Not even the internal ROM of turboR is fast enough for this fetch scheme, so additional chips on the turboR can mirror the contents of ROM into RAM, in order to make it run faster. References1. ^http://www.righto.com/2013/09/the-z-80-has-4-bit-alu-heres-how-it.html {{zilog}} 2 : Microprocessors|MSX |
| 随便看 |
|
开放百科全书收录14589846条英语、德语、日语等多语种百科知识，基本涵盖了大多数领域的百科知识，是一部内容自由、开放的电子版国际百科全书。