| 词条 | R-S-T system | |||||||||||||||||||||||||||||||||||||||||||||||
| 释义 |
The R-S-T system is used by amateur radio operators, shortwave listeners, and other radio hobbyists to exchange information about the quality of a radio signal being received. The code is a three digit number, with one digit each for conveying an assessment of the signal's readability, strength, and tone.[1][2] The code was developed in 1934 by Amateur radio operator Arthur W. Braaten, W2BSR[3][4][5][6], and was similar to that codified in the ITU Radio Regulations, Cairo, 1938.[7] ReadabilityThe R stands for "Readability". Readability is a qualitative assessment of how easy or difficult it is to correctly copy the information being sent during the transmission. In a Morse code telegraphy transmission, readability refers to how easy or difficult it is to distinguish each of the characters in the text of the message being sent; in a voice transmission, readability refers to how easy or difficult it is for each spoken word to be understood correctly. Readability is measured on a scale of 1 to 5.[8]
StrengthThe S stands for "Strength". Strength is an assessment of how powerful the received signal is at the receiving location. Although an accurate signal strength meter can determine a quantitative value for signal strength, in practice this portion of the RST code is a qualitative assessment, often made based on the S meter of the radio receiver at the location of signal reception. "Strength" is measured on a scale of 1 to 9.[8]
For a quantitative assessment, quality HF receivers are calibrated so that S9 on the S-meter corresponds to a signal of 50 μV at the antenna standard terminal impedance 50 ohms.[9] One "S" difference should correspond to 6 dB at signal strength (2x voltage = 4x power). On VHF and UHF receivers used for weak signal communications, S9 often corresponds to 5 μV at the antenna terminal 50 ohms. Amateur radio (ham) operators may also use a signal strength of "20 to 60 over 9", or "+20 to +60 over 9." This is in reference to a signal that exceeds S9 on a signal meter on a HF receiver. ToneThe T stands for "Tone" and is measured on a scale of 1 to 9. Tone only pertains to Morse code and other digital transmission modes and is therefore omitted during voice operations. With modern technology, imperfections in the quality of transmitters’ digital modulation severe enough to be detected by human ears are rare.[8]
Suffixes were historically added to indicate other signal properties, and might be sent as 599K to indicate a clear, strong signal but with bothersome key clicks.
VariationsAn example RST report for a voice transmission is "59", usually pronounced "five nine" or "five by nine", a report that indicates a perfectly readable and very strong signal. Exceptionally strong signals are designated by the quantitative number of decibels, in excess of "S9", displayed on the receiver's S meter. Example: "Your signal is 30 dB over S9." Because the N character in Morse code requires less time to send than the 9, during amateur radio contests where the competing amateur radio stations are all using Morse code, the nines in the RST are typically abbreviated to N to read 5NN.[11] In general, this practice is referred to as abbreviated or "cut" numbers.[12][13][14] See also
References1. ^{{cite web|title=Quick Reference Operating Aids (The RST System)|url=http://www.arrl.org/quick-reference-operating-aids}} 2. ^{{cite web|title=Ham Radio "RST" Signal Reporting System for CW/Phone Operation|url=http://www.acsu.buffalo.edu/~maxwell/RSTInfo.html|accessdate=24 September 2017|publisher=University of Buffalo}}} 3. ^{{cite web|title=The Radio Amateur's Handbook|url=http://www.tubebooks.org/Books/arrl_1936.pdf|accessdate=4 July 2015|pages=363}} 4. ^{{cite web|title=The RST Standard of Reporting|url=http://www.qsl.net/yb0az/rst.html|accessdate=4 July 2015}} 5. ^{{cite web|last1=Andrea|first1=Steve|title=Can You Read Me Now?|url=http://www.zs6wr.co.za/documents/rst.pdf|publisher=ARRL|accessdate=4 July 2015}} 6. ^{{cite web|author1=Arthur M. Braaten, W2BSR|title=A New Standard System of Reporting Signals|url=http://www.rsp-italy.it/Electronics/Magazines/QST/_contents/QST%201934_10.pdf|publisher=ARRL|accessdate=4 July 2015|pages=18}} 7. ^{{Cite web|url=http://www.qsl.net/wd8das/RadioCodes.pdf|title=Radiotelegraph and Radiotelephone Codes, Prowords and Abbreviations for the Summerland Amateur Radio Club|last=|first=|date=|website=|archive-url=|archive-date=|dead-url=|access-date=}} 8. ^1 2 The beginner's handbook of amateur radio by Clay Laster, Page 379, McGraw-Hill Professional, 2000, {{ISBN|0-07-136187-1}}, {{ISBN|978-0-07-136187-3}} 9. ^{{cite web|title=S9 Signal reference|url=http://www.arrl.org/forum/topics/view/956}} 10. ^{{cite book |publisher=International Amateur Radio Union |department=Region 1 |title=VHF Managers' Handbook |year=2013}} 11. ^http://www.radioing.com/hamstart/rst.html Ham Radio RST Signal Reporting System for CW Operation, by Charlie Bautsch, W5AM 12. ^{{cite web |url=http://www.qsl.net/w8rit/cw.htm |title=CW |website=QSL.net}} 13. ^http://ac6v.com/morseaids.htm#AB MORSE CODE, INTERNATIONAL EXTENSIONS AND ABBREVIATED NUMBERS 14. ^{{cite web |url=http://www.amateur-radio-wiki.net/index.php?title=Codes_and_Alphabets#RST_code |website=amateur-radio-wiki.net |title=Codes and Alphabets |at=bottom of § RST code}} 15. ^{{cite web|url=http://www.americanradiohistory.com/Archive-RCA-Review/RCA-Technical-Papers-1919-1945.pdf|title="R-S-M-Q, A Standard Method of Reporting for Telephony"}} External links
4 : Amateur radio|Encodings|Operating signals|Telecommunications-related introductions in 1934 |
|||||||||||||||||||||||||||||||||||||||||||||||
| 随便看 |
|
|||||||||||||||||||||||||||||||||||||||||||||||
开放百科全书收录14589846条英语、德语、日语等多语种百科知识，基本涵盖了大多数领域的百科知识，是一部内容自由、开放的电子版国际百科全书。