“Sensitivity (electronics)”的意思、由来-开放百科全书

词条

Sensitivity (electronics)

释义

References
External links

The sensitivity of an electronic device, such as a communications system receiver, or detection device, such as a PIN diode, is the minimum magnitude of input signal required to produce a specified output signal having a specified signal-to-noise ratio, or other specified criteria.

Sensitivity is sometimes improperly used as a synonym for responsivity.{{Citation needed|date=March 2013}}^[1]

The sensitivity of a microphone is usually expressed as the sound field strength in decibels (dB) relative to 1 V/Pa (Pa = N/m²) or as the transfer factor in millivolts per pascal (mV/Pa) into an open circuit or into a 1 kilohm load.{{Citation needed|date=March 2013}}

The sensitivity of a loudspeaker is usually expressed as dB / 2.83 V_RMS at 1 metre.{{Citation needed|date=March 2013}} This is not the same as the electrical efficiency; see Efficiency vs sensitivity.

The sensitivity of a hydrophone is usually expressed as dB re 1 V/µPa.{{Citation needed|date=March 2013}}

Sensitivity in a receiver is normally defined as the minimum input signal required to produce a specified signal-to-noise S/N ratio at the output port of the receiver and is defined as the mean noise power at the input port of the receiver times the minimum required signal-to-noise ratio at the output of the receiver:

where

= sensitivity [W]

k = Boltzmann's constant

= equivalent noise temperature in [K] of the source (e.g. antenna) at the input of the receiver

= equivalent noise temperature in [K] of the receiver referred to the input of the receiver

B = bandwidth [Hz]

= Required SNR at output [-]

Because receiver sensitivity indicates how faint an input signal can be to be successfully received by the receiver, the lower power level, the better. Lower power for a given S/N ratio means better sensitivity since the receiver's contribution is smaller. When the power is expressed in dBm the larger the absolute value of the negative number, the better the receive sensitivity. For example, a receiver sensitivity of −98 dBm is better than a receive sensitivity of −95 dBm by 3 dB, or a factor of two. In other words, at a specified data rate, a receiver with a −98 dBm sensitivity can hear signals that are half the power of those heard by a receiver with a −95 dBm receiver sensitivity.{{Citation needed|date=March 2013}}

References

1. ^Book: Sensors and Transducers Characteristics, Applications, Instrumentation, Interfacing M..J. Usher and D.A. Keating

External links

Microphone sensitivity conversion from dB at 1 V/Pa to transfer factor in mV/Pa

1 : Electrical parameters

随便看

开放百科全书收录14589846条英语、德语、日语等多语种百科知识，基本涵盖了大多数领域的百科知识，是一部内容自由、开放的电子版国际百科全书。