| 词条 | NRC tailless glider | |||||||||||||||
| 释义 |
The NRC tailless glider, also called the NRL tailless glider, was a two-seat tailless research glider designed by the Canada National Research Council and built by the National Research Laboratories, at the instigation of G.T.R. Hill who had previously designed the British Westland-Hill Pterodactyl series of tailless aircraft. DevelopmentTo research the control and stability of tailless aircraft. The National Research Council of Canada initiated a research programme using a specially designed glider, the NRC tailless glider. During the inter-war years Geoffrey T. R. Hill had designed and Westland Aircraft Limited had built a series of tailless aircraft with support from the Royal Aircraft Establishment. During World War II Geoffrey Hill served as the British Scientific Liaison Officer at the National Research Council (NRC) in Canada, where he proposed the development of a tailless research glider similar to his Pterodactyl designs.[1] DesignThe glider was constructed predominantly from wood with a single spar built from laminated wood supporting wooden built up ribs covered with a relatively thick plywood skin, which resulted in a smooth surface with minimal distortion.[2] The wing had three distinct sections, comprising a constant-chord, unswept centre section flanked by swept tapered outer sections. Primary flight controls consisted of elevons on the trailing edges of the outer wing sections for pitch and roll, with fins and rudders on the wing-tips for yaw stability and control. Trim in pitch was achieved by adjusting the incidence of movable wing tips using screw jacks. For approach and landing split flaps were fitted to the wing centre section trailing edge.[2] The undercarriage consisted of a retractable tricycle arrangement with auxiliary skids which could be lowered in case the undercarriage failed to extend. Differential brakes were fitted to the main undercarriage wheels.[2] The pilot and flight test engineer were accommodated in two separate cockpits protruding from the top surface of the wing centre section with the pilot in the port cockpit and test engineer in the starboard cockpit.[2] A comprehensive instrumentation package was fitted, with automatic recording of time, airspeed, altitude, wing tip incidence, flap angle, side-slip, roll rate, pitch rate, yaw rate, elevon hinge moment, elevon angles, rudder angles, ambient air temperature, normal acceleration (gy), longitudinal acceleration (gz), gyro attitude, pendulum attitude and bank angle. In addition radio transmissions from the pilot and test engineer were recorded on the ground.[2] Operational historyFlight testing of the aircraft began in 1946 at Namao, Edmonton, flown by S/L. Robert Kronfeld, A.F.C. RAF initially and continued by S/L. E. L. Baudoux, D.S.O., D.F.C., F/L. G. S. Phripp and F/L. G. A. Lee. Mr. T.E.Stephenson was in overall charge of the flying operations as well as scientific observations in the starboard cockpit.[2] Ground handling of the glider was found to be good, using the differential brakes. Launches were carried out as aero-tows behind an RCAF Douglas Dakota with a 350 ft nylon tow-rope, at a normal towing speed of 100 mph, but tows at 140 mph were found to pose no difficulties.[1] Flight testing was carried out predominantly in the glide after a tow to between 6,000 ft and 10,000 ft, testing being terminated at 4,000 ft to allow positioning for entering the landing circuit. Flight characteristics were found to be good with the exception of poor yaw control at low speeds. In September 1948, the glider was towed {{convert|2300|mi|km|0|abbr=on}} across Canada to Arnprior, Ontario for further testing, completing 105 hours before the project was terminated.[2] Specifications{{aerospecs|ref= RCAF[3] |met or eng?=eng |crew= 2 |capacity= |length m= 5.48 |length ft=18 |length in= |span m= 14.22 |span ft= 46 |span in=8 |swept m= |swept ft= |swept in= |rot number= |rot dia m= |rot dia ft= |rot dia in= |dia m= |dia ft= |dia in= |width m= |width ft= |width in= |height m= |height ft= |height in= |wing area sqm= |wing area sqft= |swept area sqm= |swept area sqft= |rot area sqm= |rot area sqft= |volume m3= |volume ft3= |aspect ratio= |wing profile= |empty weight kg= |empty weight lb= |gross weight kg= 1,882 |gross weight lb= 4,150 |lift kg= |lift lb= |eng1 number= |eng1 type= |eng1 kw= |eng1 hp= |eng1 kn= |eng1 lbf= |eng1 kn-ab= |eng1 lbf-ab= |eng2 number= |eng2 type= |eng2 kw= |eng2 hp= |eng2 kn= |eng2 lbf= |eng2 kn-ab= |eng2 lbf-ab= |max speed kmh=225 |max speed mph= 140 |max speed kts= |max speed mach= |cruise speed kmh= |cruise speed mph= |stall speed kmh= |stall speed mph= |stall speed kts= |range km= |range miles= |endurance h= |endurance min= |ceiling m= 3,048 |ceiling ft= 10,000 |g limits= |roll rate= |glide ratio= |climb rate ms= |climb rate ftmin= |sink rate ms= |sink rate ftmin= |Min sink speed km/h= |Min sink speed mph= |Min sink speed kts= |armament1= |armament2= |armament3= |armament4= |armament5= |armament6= }} See also{{aircontent|see also= |related=
|similar aircraft=
|lists= }} ReferencesNotes1. ^1 {{cite web |url=http://www.century-of-flight.net/Aviation%20history/flying%20wings/britain.htm |title=Flying Wings history |publisher= century-of-flight.net |date= |accessdate=2011-05-21}} 2. ^1 2 3 4 5 6 {{cite web |url= http://www.flightglobal.com/FlightPDFArchive/1948/1948%20-%201678.PDF#navpanes=0&page=1&scrollbar=0&view=FitH,0 |title=NRC Flying Wing |publisher= flightglobal. com |date= 7 October 1948 |accessdate=2011-05-21}} 3. ^{{cite web |url= http://www.rcaf.com/Aircraft/aircraftDetail.php?NRC-Pterodactyl-258 |title=NRC Flying Wing |publisher= rcaf.com |date= |accessdate=2011-05-21}} Bibliography{{refbegin}}
External links
5 : Tailless aircraft|Flying wings|Canadian sailplanes 1940–1949|Canadian aircraft 1940–1949|Canadian experimental aircraft |
|||||||||||||||
| 随便看 |
|
开放百科全书收录14589846条英语、德语、日语等多语种百科知识，基本涵盖了大多数领域的百科知识，是一部内容自由、开放的电子版国际百科全书。